Methamphetamine Presence Test

$12.95

This is a rapid test for the detection of Methamphetamine on surfaces and in solids at a cut-off of 500ng/ml. If you want to check a sample for the presence of Methamphetamine this is the test for you. If you want to test a surface (wall, desk, bench etc) for the presence of Methamphetamine this will be test you need.

Package contents:

  • 1 Methamphetamine Rapid Test
  • 1 Bottle of Buffer
  • Instructions and product insert
  • Description

    DIRECTIONS FOR USE:

    • Test device (in closed pouches), samples, and controls should be brought to room temperature (15-30°C) prior to testing. Do not open pouches until ready to perform the assay.
    • Remove the test device from its protective pouch and label the device with patient’s identification or control label.

    FOR SURFACES:

    1. Wipe with the panel over the surface in which the drugs are expected
    2. Take off the cap of supplied tube;
    3. Fill all buffers from the supplied tube of buffer into the protection cover.
    4. Insert the Multi Test slowly and carefully into the protection cover with buffer
    5. Wait for lines to appear on the membrane and read the results after 5 minutes and do not interpret the result after 10 minutes.

    FOR SOLIDS:

    1. Open the tube and put the solid into the buffer.
    2. Close the tube with dropper and cap. Shake it a short time. Wait for 30 sec
    3. Take off the cap of supplied tube;
    4. Fill all buffers with dissolved substances into the protection cover.
    5. Insert the Multi Test slowly and carefully into the protection cover with buffer.
    6. Wait for lines to appear on the membrane and read the results after 5 minutes and do not interpret the result after 10 minutes.

    INTERPRETATION OF RESULTS:

    (Please refer to the illustration above)

    NEGATIVE:* A coloured line appears in the Control region (C) and coloured lines appear in the Test region (T). This negative result means that the concentrations in the sample are below the designated cut-off levels for a particular drug tested.

    *NOTE: The shade of the coloured lines(s) in the Test region (T) may vary. The result should be considered negative whenever there is even a faint line.

    POSITIVE: A coloured line appears in the Control region (C) and NO line appears in the Test region (T). The positive result means that the drug concentration in the sample is greater than the designated cut-off for a specific drug.

    INVALID: No line appears in the Control region (C). Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for Control line failure. Read the directions again and repeat the test with a new test card. If the result is still invalid, contact your manufacturer.